Adjusting The Legrests; Angle-Adjustable Footplates; Elevating Legrests (Optional); Amputee Legrests (Optional) - B+B Pyro Start Plus Bedienungsanleitung

Pyro Start Plus Pyro Start Plus
| Lightweight wheelchair | Lightweight wheelchair
Pyro Start Plus SL Pyro Start Plus SL

5.2.2. Adjusting the legrests

Loosen the screws, then adjust the legrest to the required length and
re-tighten the screws (Fig. 9).

5.3. Angle-adjustable footplates

The angle of the footplates can be adjusted:
9.
• Unscrew the hexagon screw at the sprocket (see Fig. 10) Move the
footplate to the required position by rotating the sprocket.
• Re-tighten the sprocket screw (see Fig. 10).

5.3.1. Elevating legrests (optional)

Assemble, disassemble and swing them away as for the standard
legrests.
10.
To adjust, undo the clamp lever, then adjust the legrest to the required
length and then tighten the clamp lever.
The horizontal adjustment works as follows:
Upwards
• by lifting the footplate receiver tube you can get the legrest into
the required position.
Downwards
• Pull locking lever upwards
11.
• When doing this, hold the legrest firmly and move to the required
position
• Release locking lever; legrest locks into place automatically.
12.
62 62
| Special sizes | Special sizes
Never stand on the footplate and when swinging
it away, watch your fingers as there is a risk of
pinching
To change seat, the legrest must be swung away
or removed. Never sit on the legrest. Risk of tipping
over!
Lightweight wheelchair | Lightweight wheelchair |
Special sizes |

5.4. Amputee legrests (optional)

Assembly is the same as for the standard leg supports (chapter 5.2.1.).
The lower leg length can be adjusted once by loosening the screws on
the side of the amputation leg support (1.) and moving the calf pad to
the desired position. There is another possibility to adjust the lower leg
and thigh length by remounting the calf pad with the socket screws on
the back. For horizontal adjustment, simply pull the calf pad upwards.
To reset, pull the clamping lever (Fig. 14). Once the correct position
has been reached, release the clamping lever. The calf pad can also be
swivelled without tools and folded outwards to save space (Fig. 13).
Disassembly (Fig. 15) is done by pulling the knob (1.), then swinging it
out (2.) and pulling the amputation leg support upwards (3.).
To change seat, the legrest must be swung away
or removed. Never sit on the legrest. Risk of tipping
over!

5.5. Sideguards

5.5.1. Standard sideguard

• In order to be able to transfer more easily, both sideguards with
armrests can be swung backwards.
• Pull the locking lever gently and at the same time, swing the
sideguard to the back (Fig. 16).
• To lock the sideguard, flip it forwards and click it into place on the
armrest using gentle pressure.
• The arm pads on the sideguards are fitted in the central position
when delivered.
• They can be fitted in either the front or rear positions.
• The sideguard can be height-adjusted in four steps, to do this
remove the screw under the armrest, mount the spacers in such
order reaching the desired height and re-tighten.
Bischoff & Bischoff GmbH |2023-07-21- Revision: 3
Pyro Start Plus Pyro Start Plus
Pyro Start Plus SL
13.
14.
15.
2
1
16.
63 63