To Start The Product In The Tree - Husqvarna T540XP Mark III Bedienungsanweisung

3. Set the start lever to the start position.
To start the product on page 183 for
4. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your knee on the rear part of the top handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
cord around your hand.
CAUTION:
rope to full extension and do not let go of
the starter rope handle.
1792 - 005 - 02.11.2022
You must keep your feet in
If the saw chain rotates at
Do not twist the starter
Do not pull the starter
5. Pull the starter rope handle quickly and with force
until the engine starts.
6. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
7. Move the front hand guard rearward to disengage
the chain brake.
8. Use the product.

To start the product in the tree

Note:
Make sure that you have sufficient fuel before
you start the product.
1. Engage the chain brake.
2. Hold the product on the left or right side of your body
when you start the product.
a) If you hold the product on your left side, put your
left hand on the front handle. Hold the starter
rope handle with your right hand and thrust the
product away from your body when you start the
product.
b) If you hold the product on your right side, put
your right hand on one of the two handles. Hold
the starter rope handle with your left hand and
thrust the product away from your body when
you start the product.
183