Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna CS 2240S II Bedienungsanleitung

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or incorrect use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European
Community's Directive. The machine's
emission is specified in the Technical
data chapter and on the label.
Chain brake, activated (right) Chain
brake, not activated (left)
Ignition; choke: Set the choke
control in the choke position. This
should automatically set the stop switch
to the start position.
Air purge
Refuelling.
Chain oil fill.
Adjustment of the oil pump.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
1155356-38 Rev.3 2016-11-21

KEY TO SYMBOLS

Symbols in the operator's
manual:
Switch off the engine before
carrying out any checks or
maintenance. CAUTION! The start/
stop switch automatically returns to
run position. In order to prevent
unintentional starting, the spark
plug cap must be removed from the
spark plug when assembling,
checking and/or performing
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged
when the chain saw is started.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
–
English 7