Husqvarna T540XP Mark III Bedienungsanweisung Seite 190

3. Remove the spark arrester screen.
Note:
Do not remove the muffler from the product.
4. Clean the spark arrester screen with a steel brush.
Replace the spark arrester screen if it is damaged.
5. Install the spark arrester screen to the product.
Make sure that the spark arrester screen is correctly
attached.
™
AutoTune
Your product has the AutoTune
the carburetor automatically, which gives the best
possible adjustment. AutoTune
to weather conditions, altitude, gasoline and the type of
two-stroke oil.
CAUTION:
correctly, speak to your servicing dealer.
The product adjusts correctly after some
fuelings.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
2. Remove the starter housing.
3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
190
™
function that adjusts
™
lets the engine adapt
™
If AutoTune does not work
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. Remove the bolt in the center of the pulley and
remove the pulley.
6. Hold the starter rope handle.
7. Pull the starter rope until 1 cm of the spring guide
is shown. At the same time, press down the starter
handle cover and remove it from the starter rope
handle.
Note:
If the starter rope is broken in the starter
rope handle, push the starter handle cover down.
Use the combination wrench to remove the starter
handle cover.
1 cm/0.5 in
1792 - 005 - 02.11.2022