Husqvarna T540XP Mark III Bedienungsanweisung Seite 189

3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the chainsaw and apply full throttle.
5. Release the throttle trigger and make sure that the
saw chain stops and stays stationary.
WARNING:
when the throttle trigger is in the idle
position, speak to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the vibration damping system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 171 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
1792 - 005 - 02.11.2022
If the saw chain rotates
2. Push the start/stop switch to the STOP position. The
engine must stop.
To do a check of the muffler
WARNING:
arrester and spark arrester mounting
face may contain deposits of combustion
particles on the surfaces that may be
carcinogenic. To avoid skin contact and
inhalation of such particles when cleaning
and/or servicing the spark arrester, make
sure you always:
• wear gloves;
• clean and/or service in a well ventilated
area;
• do not use pressurized air to clean the
spark arrester screen;
• use a steel brush and brush away from
your body when cleaning the spark
arrester.
1. Remove the muffler cover.
2. Make sure that the muffler is not defective.
WARNING:
that has a defective muffler or a muffler
that is in bad condition. Return product
to a Husqvarna dealer/service station if
the muffler is defective.
A used muffler/spark
Do not use a product
189