Wiring Connection - JVC KW-DB95BT Schnellstartanleitung

Installing the unit (without mounting sleeve)
1 Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied).
Removing the unit
1 Fit the catch pin on the
extraction keys into the
holes on both sides of the
trim plate, then pull it out.
2 Insert the extraction keys
deeply into the slots on each
side, then follow the arrows
as shown below.
Part list (supplied)
(A) Trim plate (×1)
(B) Mounting sleeve (×1)
(C) Wiring harness (×1)
(D) Extraction key (×2)
(E) Flat head screw, M5 × 8 mm (×8)
(F) Round head screw, M5 × 8 mm (×8)
Use only the specified screws.
Using wrong screws might damage
the unit.

Wiring connection

Fuse (10 A)
ISO connectors
Pin
A4 Yellow
A5 Blue/white
A6 Orange/white
A7 Red
A8 Black
B1, B2 Purple ], Purple/black [
B3, B4 Gray ], Gray/black [
B5, B6 White ], White/black [
B7, B8 Green ], Green/black [
DAB antenna jack (SMB connector)
Antenna terminal
a Light blue/yellow: To the steering
wheel remote control adapter
b Yellow: Battery wire
c Yellow: A4
d Red: Ignition wire
e Red: A7
Color and function
: Battery
: Power control (12 V 350 mA)
: Car light control switch
: Ignition (ACC)
: Earth (ground) connection
: Rear speaker (right)
: Front speaker (right)
: Front speaker (left)
: Rear speaker (left)
3