Technical Data - Atag VA6111RT Benutzerinformation

Problem
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and dull.
How to activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function but-
tons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function but-
tons A and C go off.
– The indicator light for function button
B continues to flash.

Technical data

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of
the appliance door shows the electrical
connection data.
Possible cause
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause. Use a different brand of deter-
You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on.
(The rinse aid dispenser is auto-
matically off).
6. Press function button B again.
7. Switch off the appliance to keep the op-
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
Possible solution
Adjust the water softener.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
Refer to 'How to activate the
rinse aid dispenser'.
– The display shows the current set.
Rinse aid dispenser de-
activated
Rinse aid dispenser ac-
tivated
– The display shows the new adjust-
ment.
eration.
If the hot water comes from alternative
sources of energy, (e.g. solar panels,
photovoltaic panels and aeolian), use a
39
596 mm
818 - 898 mm
550 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
12