Commissioning; Open/Remove Car Body - Reely Dune Fighter 3S Bedienungsanleitung

9. Commissioning

a) Open/Remove Car Body
Pull out the two safety clips (A) at the rear end of the vehi-
cle and carefully fold the car body forward.
There is a power cable between the LEDs on the top of the
vehicle and the receiver (in the receiver box). Ensure that
it is not damaged.
If you want to disconnect the cable, pull the plug (B) from
the socket (C) of the extension cable to the receiver.
Remember the proper alignment (black cable = minus/
GND, red cable = plus/+).
Now the car body can be tipped all the way forward.
To completely disconnect the car body from the chassis,
first turn out the two little screws (D) at the joint between
the car body and the chassis with a suitable cross-head
screwdriver.
Then the car body can be removed from the chassis.
During assembly, observe that the plug (B) of the LED lamps is correctly connected to the socket of the
extension cable (C) (black cable = minus/GND, red cable = plus/+).
44