Technical Data - Meec tools 023785 Bedienungsanleitung

EN

TECHNICAL DATA

Rated voltage
Power
Speed
Sound pressure level, LpA
Uncertainty, KpA
Sound power level, LwA
Uncertainty, KwA
Always wear ear protection!
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN 62841-3-10:2015.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
INSTALLATION
1. When the product is mounted on a
workbench or the equivalent, check that
the lock knob (A) is accessible.
2. Screw the product in place with screws
(sold separately) through the two holes
(B) in the base (C).
FIG. 1
28
230 V ~ 50 Hz
85 W
5800 rpm
63 db(A)
3 db
76 db(A)
3 db
NOTE:
The product should only be mounted on a
stable surface that can support the weight
of the product, the workpiece and any other
equipment.
FITTING A GRINDING DISC
1. Lift up the arm (D) and lock it in the up
position with the locking screw (E)
2. Remove the two screws holding the disc
guard (F) and remove the guard.
3. Unscrew the locking piece (G) holding the
disc (H) in place.
4. Fit the new grinding wheel. Make sure to
fit it correctly in place.
5. Replace the locking piece.
6. Replace the disc guard.
7. Undo the locking screw and bring down
the arm.
FIG. 2
NOTE:
Do not use discs that are cracked, chipped
or worn. Check whether a disc has invisible
cracks by hanging it up from the centre hole
and tapping it with a non-metallic object,
such as the handle of a screwdriver. If the
disc is in good condition you should hear a
metallic sound. The sound will be dull and
dampened if the disc is cracked.
USE
PREPARING THE CHAIN FOR
SHARPENING
1. Lift up the arm to adjust the saw chain.
2. Clean the saw chain before sharpening.
Clean it with a non-flammable solvent.
Do not use petrol.