Safety Instructions; Technical Data - Meec Tools 024340 Bedienungsanleitung

EN

SAFETY INSTRUCTIONS

Read these instructions carefully before
assembly and use. Failure to follow all the
instructions and safety instructions can result in
a risk of serious personal injury.
SYMBOLS
Read the instructions.

TECHNICAL DATA

Capacity in wood
Splitting diameter
Bar length
Size
Weight
DESCRIPTION
Converts the chain saw to a one-man sawmill
to turn logs into planks with a thickness of
0.5-30 cm. Works for logs up to Ø53 cm and
fits chain saws with a bar length from 12"
(30 cm) - 24" (60 cm). The lightweight, but
robust framework is made of aluminium and
is easy to use. The jig has a chain saw holder
for positioning the saw when in use, a support
handle for stability, saw guard for personal
safety, and a plank thickness gauge.
ASSEMBLY
1. Put 2 screws M8 x 75 through the
adjusting strut and into the clamp. Make
sure the scale on the adjusting strut is
turned away when fitting. Screw on the
nuts below the clamp. Do not overtighten,
so that there is space for the saw bar.
FIG. 1
2. Put 2 screws M8 x 75 through the
adjusting strut, through the bar tip guard
and through the clamp. Fit hex screws
8
0.5-30 cm
Ø53 cm
12-24" (30-60 cm)
W74 x H62 x D32 cm
6 kg
in the nuts below the clamp. Do not
overtighten, so that there is space for the
saw bar.
FIG. 2
3. Fit the adjusting strut for the chain saw
end on the end piece with U-bolt, strut
clamp, 2 flat washers and connecting
nuts.
FIG. 3
4. Fasten the handle at the chain saw end in
line with the end piece with ball headed
screw and lock nut.
FIG. 4
5. Repeat in the tip end, but do not tighten
the nut (as in step 3 and step 4).
FIG. 5
6. Fit the stay and handle on the guide
stay for the power switch with on/off
switch med carriage bolts, 2 lock washers
and nuts and 1 connection nut. Fit the
composite unit on the thickness rails with
2 screws, flat washers and nuts.
FIG. 6
7. Fit the end piece on the thickness rails
with carriage bolts, 2 flat washers and hex
nuts. Tighten the nuts with your fingers.
Fit the other end piece on the thickness
rails with carriage bolts, 2 flat washers
and hex nuts. Tighten the nuts. Check
that the end pieces are in line with the
thickness rails.
FIG. 7