Meec tools 023785 Bedienungsanleitung Seite 27

must match the control diameter of the
flange. Accessories that do not fit the
attachments on the tool will be unbalanced,
vibrate excessively and can cause you to lose
control of the tool.
• Do not use damaged accessories. Before
using the tool always check the accessory
and make sure, for example, that the
edges of grinding discs are not damaged,
that there are no cracks or wear on the
backing pad, and that the steel brush does
not have any loose or damaged bristles. If
you drop the power tool or an accessory,
check that it is not damaged, or fit an
undamaged accessory. After checking and
fitting an accessory, position yourself and
other people in the vicinity away from the
direction of rotation of the accessory and
then run the tool at its maximum no-load
speed for one minute. Damaged
accessories will normally break during this
test period.
• Wear safety equipment. Depending on the
application, you should wear a visor,
goggles or safety glasses. When necessary
you should wear a dust mask, ear
protection, gloves and an apron that can
stop shavings and fragments from the
workpiece. The eye protection must be able
to stop flying debris produced by using the
tool in different ways. The dust or breathing
mask must be able to filter out the particles
produced by the tool. Prolonged exposure
to intense noise can impair hearing.
• Keep onlookers at a safe distance from the
work area. Everyone coming into the work
area must wear personal safety
equipment. Fragments from the
workpiece, or from a defective accessory,
can fly out and cause personal injury
outside the actual work area.
• Hold the tool with the insulated grips if
there is a risk of coming into contact with
hidden wiring or the power cord to the
tool. When cutting accessories come into
contact with a live wire, unprotected
metal parts on the tool can become live
and give the user an electric shock.
• Position the power cord so that it cannot
come into contact with the rotating
accessory. If you lose control, the power
cord can be cut or get stuck, and your
hand or arm could be pulled into the
rotating accessory.
• Never put down the power tool until the
accessory has completely stopped. The
rotating accessory can catch on the
surface and cause you to lose control of
the power tool.
• Do not run the tool while carrying it next
to you. Unintentional contact with the
rotating accessory can cause it to catch in
your clothes and pull it towards your body.
• Clean the ventilation grilles on the tool at
regular intervals. The motor fan sucks dust
into the tool casing and the accumulation of
metal powder can result in the risk of electric
shock.
• Do not use the power tool near
flammable materials. Sparks can ignite
these materials.
• Do not use accessories that require liquid
coolants. The use of water or other liquid
coolants can cause an electric shock.
SYMBOLS
Read the instructions.
Wear safety glasses.
Wear ear protection.
Wear dust protection mask.
Double insulation (safety
class II), does not need to be
earthed.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
EN
27