Meec tools 023785 Bedienungsanleitung Seite 26

EN
USE AND CARE
• Do not force the tool. Always use the
correct tool for the job. The tool does the
job better and safer when used at the rate
for which it was designed.
• Do not use the tool if it cannot be switched
on and off with the power switch. Power
tools that cannot be controlled with the
power switch are dangerous and must be
repaired.
• Pull out the plug and/or remove the
battery before making any adjustments,
changing accessories or putting the power
tool away. These safety precautions reduce
the risk of accidently starting the power
tool.
• Store power tools out of the reach of
children when not in use. Never allow
children, or anyone who is unfamiliar with
the power tool and these instructions, to
use the tool. Power tools are dangerous if
used by inexperienced persons.
• Keep power tools properly maintained.
Check that moving parts are properly
adjusted and do not jam, and that no parts
are incorrectly fitted or damaged. Check for
other factors that could affect functionality.
If the power tool is damaged, it must be
repaired before being used again. Many
accidents are caused by poorly maintained
power tools.
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to jam
and are easier to control.
• Use the power tool, accessories and bits
etc., in accordance with these instructions,
taking into account the actual working
conditions and the work that is to be
done. It can be dangerous to use power
tools for purposes other than those they
are intended to be used for.
• When not in use, store the tool in a dry
place out of the reach of children.
• Keep handles and grips clean, dry and free
from oil and grease. Greasy handles and
grips make it difficult to hold the tool.
26
SERVICE
• The power tool must only be serviced by
qualified personnel using identical spare
parts. This will ensure that the power tool
remains safe to use.
• A damaged power cord or plug must be
replaced by an authorised service centre
or other qualified personnel to ensure
safe use.
SAFETY INSTRUCTIONS FOR ANGLE
GRINDERS
General safety instructions for all types of
grinding.
• This power tool is intended to be used as a
grinder. Read all the safety instructions,
other instructions, illustrations and
specifications supplied with this power
tool. Failure to follow all the instructions
below can result in the risk of electric
shock, fire and/or serious personal injury.
• This power tool can be used for grinding,
steel-brushing and cutting. Using the tool
for any other purpose can be dangerous
and cause personal injury.
• This power tool is not intended to be used
for polishing.
• Do not use accessories that are not
specifically designed and recommended by
the tool manufacturer. Just because an
accessory can be connected to the power
tool does not mean it is safe to use.
• The rated speed of the accessory must be
at least equal to the specified maximum
speed of the power tool. Accessories run
faster than the specified rated speed can
break or shatter.
• The outer diameter and thickness of the
accessory must be within the rated
capacity of the power tool. Accessories of
the wrong size cannot be properly
protected and controlled.
• Threaded mounting of accessories must
match the spindle thread on the grinder. For
flange-fitted accessories, the spindle hole