Boot Options
Boot Options
This option allows you to specify your preferred settings for bootup.
The following screen appears if you select Boot Options from the main menu:
Boot Options
Boot Sequence
st
1
[Floppy Disk]
nd
2
[Hard Disk]
rd
3
[IDE CD-ROM]
*First Hard Disk Drive................. [IDE]
*Primary Display Adapter............... [Auto ]
*Fast Boot............................. [Auto ]
*Silent Boot........................... [Enabled ]
*Num Lock After Boot................... [Enabled ]
*Memory Test........................... [Disabled]
*Configuration Table................... [Enabled ]
↑↓ = Move Highlight Bar
Esc = Exit
Boot Sequence
¿
Á
This parameter allows you to specify the boot search sequence. To change the order of devices,
simply press
or
First Hard Disk Drive
This parameter appears only when you are in the Advanced Level.
This parameter specifies whether the BIOS utility will boot from an IDE hard disk drive or a SCSI
hard disk drive. The system will automatically boot from an IDE hard disk if your system does not
have a SCSI hard disk drive. The default setting is IDE.
Primary Display Adapter
This parameter appears only when you are in the Advanced Level.
Setting this parameter to Auto enables the onboard video controller. Normally, the onboard video
controller is considered as the primary display adapter. If you installed a video card into your
system, you need to disable the onboard VGA; otherwise, the video card will not function. To do
this, simply set this parameter to Disabled.
A26361-K535-Z120-1-7419
Page 1/1
.
F1 = Help
→ ← = Change Setting,
BIOS Utility
English - 69