Acer V66XA Technisches Handbuch Seite 59

Error Messages
System Error Messages (continued)
Error Message
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
IDE Drive 0 (1, 2, 3) Auto Detection Failed
Floppy Drive A Error
Floppy Drive B Error
Floppy Disk Controller Error
CPU Clock Mismatch
Serial Port 1 Conflict
Serial Port 2 Conflict
Parallel Port Conflict
Real Time Clock Error
CMOS Battery Bad
CMOS Checksum Error
NVRAM checksum Error
On Board xxx ... Conflict(s)
PCI Device Error
System Resource Conflict
IRQ Setting Error
Expansion ROM Allocation Fail
A26361-K535-Z120-1-7419
Corrective Action
Replace the disk drive or the HDD (hard disk
drive) controller. Check the HDD cable
connections and CMOS setup configuration.
Replace the disk drive or the hard disk drive
controller. Check the HDD cable connections
and CMOS setup configuration.
Replace the floppy drive.
Check the floppy drive cable and its
connections. If the cable is good and properly
connected, the floppy disk controller may be the
problem. Change the floppy disk controller or
disable the onboard controller by installing
another add-on card with a controller.
When the user changes the CPU frequency, this
message will be shown once. Then the BIOS
will adjust the CPU clock automatically.
Change the onboard serial port address in
Setup or change the add-on card serial port
address.
Change the onboard parallel port address in
CMOS Setup or the parallel port address of the
add-on card.
Check the RTC circuit or replace the RTC.
Replace the onboard lithium battery.
Run Setup again and reconfigure the system.
Run the ECU (Extended ISA Configuration
Utility) to restore the original EISA configuration
data.
Try to reassign or disable onboard device
resources.
Check the PCI card. Replace it if bad.
Run Setup to reconfigure the system.
Run Setup to reconfigure the system.
Change the I/O expansion ROM address.
System Board V66XA
English - 59