Ls-120 Drive; Ide Drives - Acer V66XA Technisches Handbuch

BIOS Utility

LS-120 drive

This parameter allows you not only to enable the LS-120 device installed in your system, but also to
specify the function of the device. The setting affects how BIOS will detect the device.
Possible settings are:
•
Normal In this setting, BIOS does not support the LS-120 drive. The drive needs the LS-120
device driver to operate.
•
Drive A BIOS recognizes the LS-120 drive as drive A. If a standard diskette drive A exists,
BIOS automatically identifies it as drive B. If a standard diskette drive B exists, it automatically
becomes inaccessible.
If two LS-120 drives exist, BIOS recognizes them as drive A and drive B, respectively.
•
Drive B BIOS recognizes the LS-120 drive as drive B. If a standard diskette drive B exists, it
becomes inaccessible.
•
Hard Disk BIOS recognizes the LS-120 drive as a hard disk. In this setting, format the LS-120
drive as any other hard disk and assign it a drive letter C, D, E, and so on. See the
documentation that came with the LS-120 drive for more information.
This parameter appears only when you are in the Advanced Level.

IDE Drives

To configure the IDE drives connected to your system, select the parameter that represents the
channel and port where the desired hard disk to configure is connected.
The following screen appears if you select any of the IDE Drive parameters:
IDE Primary/Secondary
Channel Master/Slave
Type ........................... [ Auto ]
Cylinder ..................... [ XXXX ]
Head ......................... [ XXXX ]
Sector ....................... [ XXXX ]
Size ......................... [ XXXX ] MB
Hard Disk Size > 504MB ......... [ Auto ]
Hard Disk Block Mode ........... [ Auto ]
Advanced PIO Mode .............. [ Auto ]
Hard Disk 32 Bit Access ........ [Enabled]
DMA Transfer Mode .............. [ Auto ]
CD-ROM Drive DMA Mode
↑↓ = Move Highlight Bar
Esc = Exit
64 - English
[Enabled]
F1 = Help
→ ← = Change Setting,
Disk Drives
Page 1/1
A26361-K535-Z120-1-7419