Changing Batteries - Terraillon Multithermo Light Bedienungsanleitung

Notice MultiThermo-BAT.qxd:Mise en page 1
2. Ear Mode
Remove the protective cap. The unit is now in ear
mode.
- Press the " " button. All screen symbols will
appear (fig. 1), followed by the last temperature
taken (fig. 2).
- When you hear a beep the thermometer is ready
(fig. 3), press and hold down the "
(fig. 4)
- Fit the sensor probe into the ear canal until a beep
signals the end of the measuring process.
- Release the button.
- Remove sensor from ear canal. Your temperature
will be displayed.
1
Important: To make an accurate reading, make
sure that the sensor is securely positioned in
the ear canal so that the sensor lens registers heat
generated by the eardrum. To do this, gently pull
your ear to straighten the ear canal and fit sensor
snugly by turning lightly.
(The thermometer should not be used as an
ear thermometer on babies between the age of
0-12 months.)
10
" button.
2 3 4
Ear drum
Pinna
Auditory canal
9/02/10
MEMORY
To display the last temperature taken, press the "
button, the temperature will appear along with its
memory number.
To display the previous; memories,
press the " " button and the
memory numbers will appear.
Memory Number

CHANGING BATTERIES

When the symbol " " appears, this means
that the battery is low. When the display shows the
symbol " " as well and you hear a warning beep,
this means that the battery no longer works and
should be changed. Press any button to stop war-
ning beep.
Button to
open battery
compartment
- Open the battery case by sliding off the cover on
the back of the unit.
- Remove used battery.
- Replace with a lithium 3V CR2032 battery in
designated area. The larger part of the battery
should be facing up. You should still be able to
see the "+" sign when battery is installed.
- Slide the cover back on. Unit is ready for imme-
diate use.
17:07 Page 10
"