Product Description; First Usage - Terraillon Multithermo Light Bedienungsanleitung

Notice MultiThermo-BAT.qxd:Mise en page 1
PRODUCT
DESCRIPTION
Support

FIRST USAGE

1. Power
A 3V (CR2032) battery is included inside unit.
Unit is ready for immediate use. Please remove the
battery tab before use.
2. Setting the Clock
Set the clock when using for the first time or after
changing the battery.
- Open the battery case by sliding off the cover on
the back of the unit.
- Push the "time setting" button. The hour numbers
will start blinking.
- Push the "
- Push the "time setting" button again to set. The
minute numbers will start blinking.
Probe cap
Temperature
reading
button
10-memory
recall button
Time set
button
Battery
compartment cover
" button to select.
9/02/10
- Push the " " button to select.
- Push the "time setting" button again to set. While
not in use, the screen will display the time and
Probe
room temperature.
3. How to choose the temperature measuring
unit (F° or C°)? p. 12.
TAKING TEMPERATURE
When the protective cap is attached, the unit is
automatically in forehead measure mode.
It is easily adapted for the ears by removing the
protective cap.
In both modes, if the temperature is above 38°C,
the temperature measurement button turns red
for five seconds.
1. Forehead Mode
The cap attaches by fitting over the probe.
- Press the " " button. All screen symbols will
appear (fig. 1), followed by the last temperature
taken (fig. 2).
- When you hear a beep, press and hold down the
" " button.
- Hold the sensor against one of your temples.
- Slide the sensor across your forehead to the other
temple.
- Release the button to stop measuring. You will
hear a beep and the temperature will be displayed
(fig. 3).
The displayed forehead temperature would be the
same as the oral temperature.
Exterior conditions can influence forehead tempe-
rature. If you are unsure of the results, try taking
your ear temperature.
1
17:07 Page 9
3
2
9