Before Putting Into Operation; Filling The Water Tank; Temperature Settings - ECG NZ 212 Bedienungsanleitung

DESCRIPTION
Filling hole lid
Sprinkling jet
Ironing surface with
holes for steaming
OPERATING INSTRUCTIONS

Before putting into operation

Remove the protective foil from the soleplate fi rst! The iron must be used and stored on a stable surface.
When ironing for the fi rst time, heat the iron to the highest degree without using water. During this process,
smoke and bad smell may come from the iron, though will vanish shortly. The water reservoir can be fi lled
afterwards. After fi lling and heating the iron, leave it to produce steam for at least 1 minute while occasionally
pressing the steam button. This removes any residue from production. We recommend trying the iron on
some common fabric, e.g. a dish towel, prior to using it on your laundry for the fi rst time.

Filling the water tank

Be sure the iron is unplugged from the electrical outlet before fi lling with water!
Tilt the iron and fi ll with water until the line marked max. is reached (fi g. 1).
Use distilled or demineralized water to prevent scale. The cup included with the product must be used to fi ll
the iron. The iron must not be fi lled with water directly from the water tap!

Temperature settings

Before ironing, sort the garments according to the international textile care and labeling codes found on
tags. If these are missing, separate the garments based on the type of fabric.
EN
30
Steam burst button
Watering button
Steam control,
steamless ironing
Power input
protection
Max. fi ll level
Temperature
regulator