Tp Search Function (Fm Stations Only) - Yamaha RS300B Bedienungsanleitung

FM/AM TUNING
Notes
• It may take a while for this unit to receive all of the Radio Data
System data from the station.
• If the signals being received are not strong enough, this unit
may not be able to utilize the Radio Data System data. In
particular, the "RADIO TEXT" mode requires a large amount
of data and may not be available even when the other Radio
Data System display modes are available.
• If reception is poor, set FM Mode to "MONO" (see page 18).
• If the signal is weakened by external interference while this unit
is receiving the Radio Data System data, the reception may be
cut off unexpectedly.
• When the "RADIO TEXT" mode is selected, this unit can
display program information using a maximum of 128
alphanumeric characters, including the umlaut symbol.
Unavailable characters are displayed as "_" (underscore). The
displayed information scrolls continuously.
24
En
TP Search function
(FM stations only)
This unit can automatically search for Radio Data System
stations that provide traffic programs (TP).
TP
TP
1
Press TP on the front panel (or TP on the
remote control) to search for a TP station.
"TP SEARCH" is displayed on the front panel
display for about 3 seconds, and then the unit starts
searching.
When a TP station is received, the TP indicator lights
up and the unit stops searching.
y
To search for the next TP station, press TP again.
Notes
• Press TP during TP search to cancel.
• If no TP Stations are found, "TP NOT FOUND" is displayed on
the front panel display and this unit returns to the state before
searching.
TP indicator