Remote Control - Yamaha RS300B Bedienungsanleitung

■ Bluetooth™
The following messages may be displayed on the front panel display in certain situations.
Message
The Bluetooth Wireless Audio Receiver
Searching...
and the Bluetooth component are in the
process of pairing.
The Bluetooth Wireless Audio Receiver
and the Bluetooth component are in the
process of establishing a connection.
The pairing is completed.
Completed
The pairing is canceled.
Canceled
The connection between the Bluetooth
Connected
Wireless Audio Receiver and the
Bluetooth component is established.
The Bluetooth component is
Disconnected
disconnected from the Bluetooth Wireless
Audio Receiver.
The Bluetooth component is not found.
Not found
Pairing may not have been achieved.

■ Remote control

Problem
Wrong distance or angle.
The remote control
does not work nor
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
Status/Cause
Cause
Remedy
During pairing:
– pairing must be performed on the Bluetooth
component and this unit simultaneously. Check if
the Bluetooth component is in pairing mode.
During connecting:
– check if the Bluetooth component is turned on.
– check if the Bluetooth component is within 10 m
(32 feet) of the Bluetooth Wireless Audio
Receiver.
Try pairing again.
Remedy
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
TROUBLESHOOTING
See
page
—
—
—
—
—
—
—
28
See
page
9
—
9
37
En