Yamaha RS300B Bedienungsanleitung Seite 36

TROUBLESHOOTING
Problem
Incorrect cable connections.
A "humming" sound
can be heard.
No connection from the turntable to the
GND terminal.
The record is being played on a turntable
The volume level is
with an MC cartridge.
low while playing a
record.
The component connected to the TAPE
The volume level
REC or LINE 1 REC output jacks of this
cannot be increased,
unit is turned off.
or the sound is
distorted.
The power of this unit is turned off, or this
The sound is
unit is set to standby mode.
degraded when
listening with the
headphones
connected to the CD
player or the tape
deck connected to
this unit.
The loudness control function is
The sound level is
operating.
low.
The PURE DIRECT switch is turned on.
Using the BASS,
TREBLE, BALANCE
and LOUDNESS
controls does not
affect the tonal
quality.
34
En
Cause
Connect the audio plugs firmly. If the problem
persists, the cables may be defective.
Make the GND connection between the turntable and
this unit.
The turntable should be connected to this unit through
the MC head amplifier.
Turn on the power of the component.
Turn on the power of this unit.
Turn down the volume, set the LOUDNESS control
to the FLAT position, and then adjust the volume
again.
The PURE DIRECT switch must be turned off to use
those controls.
Remedy
See
page
10
10
—
—
13
15
14