Spare Parts And Accessories - 3M PELTOR ProTac III Bedienungsanleitung

10.1. REMOVING AND REPLACING THE EAR
CUSHIONS
H:1 To remove the ear cushion, slide your fingers under
the inside edge of the ear cushion and firmly pull straight
out.
H:2 Remove existing liner(s) and insert new foam liner(s).
H:3 Fit one side of the ear cushion into the groove of the
earcup and then press on the opposite side until ear
cushion snaps in place.
10.2. REPLACING THE CARRIER ATTACHMENT
PLATE
For proper fitting on different compatible carrier devices,
the carrier attachment plate may need to be replaced.
Find the recommended attachment in Table F.
The headset comes assembled with P3E carrier
attachment. Plates can be obtained from your dealer. A
screwdriver is needed to replace the carrier attachment
plate.
Q:1 Loosen the screw holding the plate and remove the
plate.
Q:2 Attach the appropriate plate while ensuring the left (L)
and right (R) designated plates are on the appropriate
earmuff, if applicable, and then tighten the screw.

11. SPARE PARTS AND ACCESSORIES

Article number
3M™ PELTOR™
HY220 Hygiene Kit
3M™ PELTOR™
FL6CE 3.5 mm cable
3M™ PELTOR™
HY100A Clean
3M™ PELTOR™
Covers ProTac III,
black, 1 pair,
220323-631-SV/1
Name
Hygiene kit consisting of
two (DK034) thin foam
liners, two (DK042) thick
foam liners and two snap-in
cushions.
3.5 mm cable to connect
an external device.
Single-use protector for the
cushions.
Package of 100 pairs.
Left and right hand covers
to replace existing covers
on the 3M™ PELTOR™
ProTac III Headset. Fits
both the headband and the
helmet attached version.
12. STORAGE
• Store the product in a clean and dry area before and
after use.
• Always store the product in the original packaging
and away from any sources of direct heat or sunlight,
dust and damaging chemicals.
• Storage temperature range: –20°C (–4°F) to 40°C
(104°F).
• Relative humidity: <90%.
• Headband versions:
Make sure that no force is applied to the headband or
neckband and that the cushions are not compressed.
• Carrier attachment version:
Ensure the earmuffs are in work mode position (see
figure G:9) and that the cushions are not
compressed.
• NOTE: Remove the batteries when storing the
product for long periods of time.
13. WARRANTY AND LIMITATION OF
LIABILITY
NOTE: The following statements do not apply in Australia
and New Zealand.
Consumers should rely on their statutory rights.
13.1. WARRANTY
In the event any 3M Personal Safety Division product is
found to be defective in material, workmanship, or not in
conformity with any express warranty for a specific
purpose, 3M's only obligation and your exclusive remedy
shall be at 3M's option, to repair, replace or refund the
purchase price of such parts or products upon timely
notification of the issue by you and substantiation that the
product has been stored, maintained and used in
accordance with 3M's written instructions.
EXCEPT WHERE PROHIBITED BY LAW, THIS
WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY
EXPRESS OR IMPLIED WARRANTY OF
MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE OR OTHER WARRANTY OF QUALITY, OR
THOSE ARISING FROM A COURSE OF DEALING,
CUSTOM OR USAGE OF TRADE, EXCEPT OF TITLE
AND AGAINST PATENT INFRINGEMENT.
3M has no obligation under this warranty with respect to
any product that has failed due to inadequate or improper
storage, handling, or maintenance; failure to follow
product instructions; or alteration or damage to the
product caused by accident, neglect, or misuse.
7
EN