Mobitronic RV-700 Montage- Und Bedienungsanleitung Seite 35

Safety and installation instructions
Depending on the vehicle's equipment, the following data may have to be
reprogrammed:
Radiocode · Clock · Timer · Board computer · Seat position
Instructions on how to re-set these can be found in the relevant operating
instructions.
Warning! Ensure that the parts of the video system installed in
the vehicle are securely fastened so that they cannot come loose
under any circumstances (sudden braking, road accident) and
cause injury to the driver / passengers.
When positioning the monitor ensure that it is not installed within
the effective area of one of the AIRBAGS. Otherwise triggering of
the air bag may cause injury.
Caution! To check the voltage in electric cables, use only a diode
test lamp (see✎ A 1) or a voltmeter (see ✎ A 2). Test lamps
(see✎ A 3) which light up take too much current and the vehicle
electronics may be damaged.
Caution! To avoid damage, always ensure that there is enough
clearance for the drill bit to emerge (see✎ A 4). Every drill hole
must be deburred and treated with a rust proofing agent.
Attention! When routing the electrical connections ensure that
they:
1. Are not bent or twisted (see ✎ A 5 a)
2. Do not rub against edges (see ✎ A 5 b)
3. Are not routed through sharp-edged holes or openings without
protection (see ✎A 5 c).
The camera is waterproof. However, the seals are not designed to
withstand a high-pressure cleaner (see ✎ A 6).
Do not open the devices as this impairs their water-tightness and
operability (see ✎A 7).
Do not pull the cables as this may impair the water-tightness and
operability of the camera (see ✎ A 8).
The camera is not designed for operating under water (see A 9).
35