Maintenance; Troubleshooting - Num'axes Canicom 200 First Gebrauchsanleitung

- Do not place or keep the unit in places exposed to high temperatures.
- It is necessary to replace the battery every two years, even if the unit has not been used for long periods.
- Never leave a discharged battery in the unit: leakage could damage your CANICOM 200 FIRST.
- Remove the battery from the receiver collar and the remote control if you are not using the appliance
for 3 months or more. The collar will memorize the configuration chosen (coding).
- Keep your CANICOM 200 FIRST unit out of reach of children. It is not a toy for you or your children.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.

Maintenance

- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain watertightness, we recommend the replacement of the seal located in the receiver
collar every year.

Troubleshooting

Should your CANICOM 200 FIRST stop working or develop a fault, first read this user's guide over, then
check the batteries (see § Checking/replacing battery of remote control and § Checking replacing battery
of receiver collar) and replace them if necessary and retry. Also check that you are using the product
correctly.
If you encounter any problems, re-code the receiver collar (ref. re-coding procedure).
Re-initialize the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 6).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor or check out on www.numaxes.com.
Gb - 29
Diagram 6
Reset: connect
the 2 supports of
the battery