First Use From New - Num'axes Canicom 200 First Gebrauchsanleitung

First use from new

 Fitting the battery in the receiver collar
- Unscrew the 4 screws of the top of CANICOM using a screwdriver.
- Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery
housing (ref. Diagram 3).
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing.
Check the polarity before trying again.
- Before putting the lid back in place check that the rubber seal is in its groove.
- Screw up the 4 screws with care (do not overtighten them).
Polarity « - » of the battery
 Activate/deactivate the remote control
Remote control is supplied with battery fitted.
- Activate: as soon as the battery is in place, the remote control is ready for use.
- Deactivate: if the remote control is not to be used for a long period or if you wish to turn it off, you
should remove the battery from its housing.
 Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch on/off the receiver collar.
Gb - 22
Diagram 3
Polarity « + » of the battery
Seal