Cleaning And Maintenance; Hygiene Programme; Cleaning The Machine; Z Descaling The Machine - Schulthess Fust NOVAMATIC WA 6780 Bedienungsanleitung

Cleaning and Maintenance

Hygiene programme

This washing machine is equipped with a hygiene
display and a hygiene programme.
This programme allows you to execute a hygiene
cleaning process of the machine. This is recommended
in particular if a fellow occupant has washed at a tem-
perature of less than 60°C before you. The machine will
indicate this displaying «70°C hygiene programme»
whenever you select a programme under 60°C.
In this case start your laundry day with a 60°C or 95°C
wash programme or select the hygiene programme.
Note
 If you want to do without additional hygiene measures,
you can also start your selected programme directly using
the start button.
Starting the hygiene programme
«Coloureds 60°C» + «Start»
The hygiene programme is started by holding down the
button «Coloureds 60°C» and pressing the Start button.
Do not use the hygiene programme with laundry and
detergent!

Cleaning the machine

Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water
or clean it with a steam cleaner.
Do not use solvents! These substances can damage
parts of the machine, produce poisonous vapour and
carry the risk of explosion.
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-abra-
sive cleaning product.
The side walls of machines with a chrome steel finish
should not be cleaned with chrome steel cleaner under
any circumstances.
Descaling the machine
If the correct amounts of detergent are used, descaling
is no longer necessary in general.
Descalers contain acids, can attack parts of the machine
and cause discolouration of laundry.
If you do, however, wish to descale the machine, follow
the manufacturer›s instructions on the packet.
Limescale formation depends largely on the hardness of
the water. To avoid water damage, we recommend
having this checked by a specialist after around 5 years
of fault-free operation.
Cleaning the drum
Rust marks caused by metal parts standing still for
lengthy periods can be removed with a chlorine-free
cleaning product (look at the description of the ingre-
dients on the pack).
Never use steel wool!
45
Water supply hose
Only for machines without water stop. To avoid water
damage, we recommend having this checked by a
specia list after around 5 years of fault-free operation.
Frost protection
If the machine is in a room susceptible to frost, all residual
water must be removed from the detergent pump and
water supply and drain hoses immediately after use.
Emptying the drain pump
See chapter «Emergency emptying».
Emptying the water supply hose
 Turn off the water supply
 Screw off the hose at the tap, let the water run into a
bowl.
 Screw the hose back onto the tap.
Cleaning the detergent drawer
1.
Pull the detergent drawer out until it stops.
2.
Press down in the middle of the softener section cover,
and pull the drawer all the way out.
3.
Remove the divider.