Z Standby Function; Z Optical Interface; Z Reduced Mains Power; Z Default Language - Schulthess Spirit topLine 7540i Bedienungsanleitung

Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off in energy saving mode when no wash pro-
gramme is running or laundry weighing is carried out.
The display will show «ZZZ».
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Reduced mains power (ex factory OFF)
Select «Extended basic settings»!
If the connected load is reduced, the programme times
will be extended accordingly.
Off = 400V 3N ~ 4,4 kW / 10 AT
On = 230V 2N ~ 2,1 kW / 10 AT
Default language (ex factory GERMAN)
Select «Extended basic settings»!
If another language is temporarily selected via the lan-
guage selection button or buttons
programme end, in stand by mode or after a long stand-
still, the setting reverts back to the default language.
Door open at programme end (ex factory OFF)
Select «Extended basic settings»!
If this function is switched on, the door will open auto-
matically at the end of the programme.
Information for testing institutes and users
Energy labelling according to Directive 2010/30/EU and
EN 60456 is based on the «ecoPlus» programmes for
coloureds at 60°C, full and half loads, and coloureds at
40°C, half loads.
Annual energy consumption: 175 kWh
Annual water consumption:
48
e , after
9300 litres

Cleaning and Maintenance

Hygiene programme

This washing machine is equipped with a hygiene
display and a hygiene programme.
This programme allows you to execute a hygiene clean-
ing process of the machine. This is recommended in par-
ticular if a fellow occupant has washed at a temperature
of less than 60 °C before you. The machine will indicate
this displaying «70 °C hygiene programme» whenever
you select a programme under 60 °C.
In this case start your laundry day with a 60 °C or 95 °C
wash programme or select the hygiene programme.
Note
 If you want to do without additional hygiene measures,
you can also start your selected programme directly using
the start button.
Starting the hygiene programme
+
The hygiene programme is started by holding down the
button and pressing the Start button.
Do not use the hygiene programme with laundry and
detergent!

Cleaning the machine

Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water
or clean it with a steam cleaner.
Do not use solvents! These substances can damage
parts of the machine, produce poisonous vapour and
carry the risk of explosion.
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-abra-
sive cleaning product.
The side walls of machines with a chrome steel finish
should not be cleaned with chrome steel cleaner under
any circumstances.
Descaling the machine
If the correct amounts of detergent are used, descaling
is no longer necessary in general.
Descalers contain acids, can attack parts of the machine
and cause discolouration of laundry.
If you do, however, wish to descale the machine, follow
the manufacturer›s instructions on the packet.
Limescale formation depends largely on the hardness of
the water. To avoid water damage, we recommend
having this checked by a specialist after around 5 years
of fault-free operation.