Z Spin Speed Reduction; Z Rinsing Stop; Z Quick Wash; Basic Settings - Schulthess Fust NOVAMATIC WA 6780 Bedienungsanleitung

Spin speed
This function is used to select a lower spin speed or a
rinse stop for a more gentle treatment of the laundry,
for example with delicate laundry (see next section).
Without spin speed reduction the laundry will be spun
at normal spin speed (see chapter «Basic settings/Spin
speed reduction»).
The spin speed depends on the programme chosen.
By pressing this button the spin speed can be reduced
By pressing the button repeatedly it can be reduced in
200 or 100 rpm increments. The slowest possible spin
speed is 200 rpm.
The spin speed can also be changed while a programme
is operating but not during the spin cycle however.
Increased spin speed
If the button spin speed is pressed again after «00», you
can select an increased spin speed (1500 rpm). The spin-
ning intensity of the laundry will be increased.
Money-saving tip
If the laundry is to be dried in a tumble dryer, select a
high spin speed since well-drained laundry needs much
less energy and time for machine drying.
Rinsing stop
The «Rinsing stop» function is used to avoid creasing of
sensitive fabrics. The laundry is held in the last rinse
water. Select rinsing stop by reducing the spin speed until
you see «Rinsing stop» on the display.
You can end the programme by draining the laundry
without spinning or by spinning (see chapter «Washing/
Ending the programme with rinsing stop»).
Quick Wash
The programme can be shortened or aborted by pres-
sing the quick wash button.
X See chapter «Washing/ Cancelling the programme»).
This button can also be used to select special programmes.
X See chapter «Washing/Particular programmes».
 The additional function «Quick Wash» is not available
with the autoClean programme.
42

Basic Settings

The machine has basic settings from the factory. It can
be adapted to the user›s individual needs either when
first used or later using the following functions.
The basic settings can only be changed if no wash pro-
gramme is running. To change a basic setting, it is first
necessary to hold the programme button pressed and
then press the quick wash button. The corresponding
function is shown on the digital display. The display
changes when the quick wash button is pressed repea-
tedly with the programme button held down.
The basic settings on your machine may be blocked.
However, the time setting and language selection func-
tions are available.
Example:
Additional rinse (ex factory OFF))
«PROFI CLEAN» + «Quick wash»
To improve the rinse results in soft water areas or for
allergy sufferers, switch on the extra rinse.
Water level when washing (ex factory NORMAL)
«Coloureds 20°C» + «Quick wash»
If the function is set to «increased», the water level is
higher during washing.
Water level when rinsing (ex factory NORMAL)
«Coloureds 20°C» + «Quick wash»
If the function is set to «increased», the water level is
higher during rinsing.
Spin speed reduction (ex factory OFF)
«Coloureds 60°C» + «Quick wash»
Wash programmes
Boil / Coloured wash
Easy care wash
Delicate wash
Wool
Special programmes
Function switched off
Function switched on
Spin speed in rpm
Off Level 1 Level 2
reduction reduction
1500 1200 1000
800 800 600
600 600 400
800 600 400
600 600 400