Battery Type; Package Contents - DeWalt DCS397T2 Bersetzt Von Den Originalanweisungen

EngLIsh
implied, is given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.
Transporting the FLEXVOLT
The D WALT FLEXVOLT battery has two modes: Use
TM
e
and Transport.
Use Mode: When the FLEXVOLT
a D WALT 18V product, it will operate as an 18V battery. When
e
the FLEXVOLT battery is in a 54V or a 108V (two 54V batteries)
TM
product, it will operate as a 54V battery.
Transport Mode: When the cap is attached to the FLEXVOLT
battery, the battery is in Transport mode. Keep the cap for
shipping.
When in Transport mode, strings
of cells are electrically
disconnected within the pack
resulting in 3 batteries with a
lower Watt hour (Wh) rating as compared to 1 battery with a
higher Watt hour rating. This increased quantity of 3 batteries
with the lower Watt hour rating can exempt the pack from
certain shipping regulations that are imposed upon the higher
Watt hour batteries.
For example, the Transport
Example of Use and Transport Label Marking
Wh rating might indicate
3 x 36 Wh, meaning 3
batteries of 36 Wh each.
The Use Wh rating might
indicate 108 Wh (1 battery implied).
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE: Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
32
TM Battery
TM battery stands alone or is in
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
TM
Discard the battery pack with due care for
the environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other than
e
the designated D
charger may make them burst or lead to other
dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).

Battery Type

These cordless alligator saws operate on a 54 V battery pack.
These battery packs may be used: DCB546, DCB547, DCB548.
Refer to Technical Data for more information.

Package Contents

The package contains:
1 Alligator saw
1 TCT saw blade set for low density building block
(DCS396T2, DCS397T2 only)
1 TCT saw blade set for medium density building block
(DCS398T2 only)
1 Hex key
2 Li-Ion battery packs (T2 models)
1 Charger (T2 versions only)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
WALT batteries with a D WALT
e e