Prior To Operation - DeWalt D26414 Bersetzt Von Den Originalanweisungen

english
SET AND FORGET TEMPERATURE CONTROL SYSTEM
D26414
The desired temperature is stored in the memory
of the tool. Each time the heat gun is turned on,
the heat gun heats to the last temperature setting,
with respect to air flow. If unsure about the setting,
always start with a low temperature setting and
gradually increase the temperature until the desired
setting is reached.
Applications
The table below suggests settings for different
applications.
Setting Applications
Low • Drying paint and varnish
• Removing stickers
• Waxing and dewaxing
• Drying wet timber prior to filling
• Shrinking PVC wrapping and
insulation tubes
• Thawing frozen pipes
Medium • Welding plastics
• Bending plastic pipes and
sheets
• Loosening rusted or tightly
fastened nuts and bolts
High • Removing paint and lacquer
• Soldering plumbing joints
• Removing linoleum or vinyl
floor tiles
To Attach the Correct Accessory
This tool is supplied with a set of accessories for
different applications.
Icon Description
Cone nozzle
50 mm Fish
tail surface
nozzle
1. Make sure the on/off switch (A) is in position O
and the tool is disconnected from the power
source. Ensure the nozzle has cooled down.
2. Place the desired accessory onto the nozzle.
28
Purpose
Shrink sleeving (heat
over concentrated
small area)
Drying, removing
paint, removing vinyl
or linoleum, thawing
(heat spread over
wide area)
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
WARNING: Make sure the nozzle
ALWAYS points away from you and any
bystanders.
WARNING: DO NOT drop anything into
the nozzle.
Proper Hand Position (Fig. 2, 3)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
WARNING: Do not place your other
hand over the air vents (Fig. 3).
Proper hand position requires one hand holding the
tool as shown in Figure 2.

Prior to operation

1. Attach the correct accessory recommended for
the application.
2. Turn the air temperature adjustment knob (D) to
desired air temperature.
Switching On and Off (Fig. 4)
1. Push the on/off switch (A) to the desired air flow
settings:
I: 240 liter/min (50ºC–400ºC)
250 liter/min (50˚–400˚C)] (D26414)
A low air flow to heat up the workpiece
slowly.
II: 450 liter/min (50˚–600˚C)
500 liter/min (50˚–600˚C) (D26414)
A high air flow to heat up the workpiece
quickly.
2. To turn the tool off, push the on/off switch (A)
to position O. Disconnect the tool from the
power source and let the tool cool down before
moving or storing it.