Electrical Safety - DeWalt D26414 Bersetzt Von Den Originalanweisungen

• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (Fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. On/off switch
B. Air vents
C. Kick-off stand
D. Air temperature adjustment knob (D26411)
LCD air temperature indicator and adjuster
(D26414)
E. Nozzle
F. Tool hanging ring
G. Heat barrel cover
INTENDED USE
Your heat gun has been designed for stripping
paint, soldering pipes, shrinking PVC, welding and
bending plastics as well as general drying and
thawing purposes.
WARNING: Do not use under wet
conditions or in presence of flammable
liquids or gases.
The heat gun is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
e
accordance with EN60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm
2
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Air Temperature (Fig. 1)
D26411
The air temperature can be adjusted to suit a wide
range of applications. Turn the air temperature
adjustment knob (D) clockwise or counterclockwise
for higher or lower heat.
D26414
• Press and release the LCD air temperature
indicator and adjuster (D) to set the desired
temperature in 10˚ C increments.
• To continously increase or decrease the
temperature press and hold the LCD air
temperature indicator and adjuster (D).
• Release the indicator when desired temperature
or minimum/maximum temperature is reached.
• The display shows the actual rising/falling
temperature until the desired temperature is
reached.
english
; the maximum length
27