Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Make absolutely sure it is safe to rotate the
bow thruster without closing the casing!
• Test the operation of the bow thruster.
If it is found during test running that the thrust direction does not
correspond with the direction switch on the control panel then the
green (no. 1) and the yellow (no. 4) wires on the relay must be inter-
changed.
Do NOT test the bow thruster while the ship is out of water, un-
less you are certain that everyone is at a safe distance from the
thrust tube.
Never allow the bow thruster to run for longer than 5 seconds
with the ship out of water.
• Fit the cover.
• Place the packing supplied between the contact surface of the lid
and the motor housing. Ensure the packing is placed correctly.
• Tighten the bolts with 5 Nm torque.
18
020586.01
D
anger
W
!
arning
vetus® Operation manual and installation instructions bow thruster BOW3512EI 'Ignition Protected'
4
1
(11 x)
1 4
Werbung
Inhaltsverzeichnis
