Cordless Shaving - Silvercrest 277761 Bedienungsanleitung

Cordless shaving

CAUTION! MATERIAL DAMAGE!
► This appliance is not suitable for wet shaving!
This shaver can be used without the power cable. In this case, you
must charge the appliance before initial use (see section "Charging
the rechargeable battery with/without the charger").
1) If not already attached, attach the protective collar 4 from the
bottom onto the cutting unit 2 (see fold-out page).
2) Fit the cutting unit 2 with the attached protective collar 4 onto
the drive shaft 1. Make sure that the protective collar 4 is fi tted
correctly onto the hand element.
3) Remove the protective cap t.
4) Press the ON/OFF button 5. The symbol
charge indicator 8 and the
as soon as the shaver starts up.
NOTE
► The best results are achieved if used on dry skin.
► It can take 2 to 3 weeks until the skin is accustomed to the dry
shaving system.
5) Move the shaving heads 3 with straight and circular motions
over the skin.
6) After you have covered all the areas you want to shave, press
the ON/OFF button 5. The appliance stops.
The display disappears at once.
7) Clean the shaver after every use with the supplied brush r.
For a more thorough cleaning, read the section "Cleaning and
care".
│ GB │ IE
■ 36
of the battery
logo are displayed
SRR 3.7 D5