What If There Are Problems; Disposal - Beurer LB 12 Gebrauchsanweisung

IMPORTANT
• Never submerge the base in water.
• Important! Empty the water from the base unit via the side rim. Ensure that no water gets inside
the device, e.g. via the air outlet or the control dial.
• Completely clean the bottle and the air humidifier if the device has not been used for over
three days.
• Clean the device using only the methods specified.
• Do not use any solvent-based cleaning products.
• Use only a mild detergent or vinegar/vinegar-based cleaner to perform cleaning or disinfection
work.
Clean all parts that come into contact with water on a weekly basis. Let the device cool down for ap-
prox. 60 minutes.
Completely remove the mist outlet, then remove the top in an upward direction.
• Make sure that the ultrasonic membrane always remains free from limescale so as to ensure a long
service life. Always use the cleaning brush for this purpose and apply standard descaling agents.
Leave the descaling agent to work for as long as is required to dissolve all the limescale and dirt
deposits. To avoid damaging the ultrasonic membrane, never scrape with sharp, hard objects. Rinse
out the base if necessary.
• Wipe the interior of the base with a cloth. Use a mild cleaning product. Rinse out the base if necessary.
• Wipe the exterior housing of the base with a damp cloth.
• Clean all removable parts, such as the bottle, bottle adapter, mist outlet and top, with a mild detergent
or vinegar/vinegar-based cleaner. Clean the parts thoroughly, particularly the bottle.
• Bottle adapter, mist outlet and top are dishwasher-safe.
Dry the parts with a soft cloth and only reassemble them when they are completely dry.
For storage and easy transport, e.g. for travel, a storage pouch is available.

9. What if there are problems?

Problem
No mist is produced
The mist has a strange
smell

10. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of
its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
Cause
The water level is too low; the water
tank is empty.
The mains cable is not plugged in.
Stale or dirty water.
18
Solution
Fill the water tank.
Connect the plug.
Empty the base unit and the water
tank and clean them thoroughly.
Fill the water tank with fresh water.