Descaling The Water Tank; Storage; Accessories And Replacement Parts; What If There Are Problems - Beurer LB 300 Plus Gebrauchsanweisung

Descaling the water tank

1. Fill the water tank
2. Leave for one hour.
3. Rinse out the water tank
4. Repeat this procedure if necessary.

8.7 Storage

When you are not using the device, we recommend that you carry out the following actions:
1. Empty any remaining water from the water tank
2. Dry the filter using the filter drying function (see section "8.1 Filter drying function") or allow it to air dry.
5
3. Clean the filter
5
4. Store the air humidifier in its original packaging and in a dry environment.
5. Store the humidifier without weighing it down.

9. ACCESSORIES AND REPLACEMENT PARTS

To purchase accessories and replacement parts, please visit www.beurer.com or contact the correspond-
ing service address (according to the service address list) in your country. Accessories and replacement
parts are also available from retailers.
Designation
Replacement filter

10. WHAT IF THERE ARE PROBLEMS?

Problem Possible cause
Mains plug not plugged in
Air humidifier Motor unit not seated properly on
will not turn on. water tank
Water tank is empty
The air humidifi- The desired target humidity has
er does not start already been reached or exceeded
Filter dirty
Insufficient air
flow
Blocked air inlet or outlet
Foreign object in air inlet or air outlet
The air humidifi-
Filter clogged
er is very noisy
Air humidifier is not standing on a
flat and level surface
with descaling solution up to the "Max." marking
9
with running water.
9
, water tank , filter holder
9
.
9
and water level sensor
8
Item number and/or order number
110.005
Solution
Insert the mains plug into a suitable socket.
Check for correct positioning. There must
be no gap between the motor unit and the
water tank.
Fill the water tank
If you want a higher target humidity level,
set this using the target humidity button (see
section "7.2 Setting target humidity").
Clean the filter (see section "8.2 Cleaning
the filter") and/or descale (if necessary
replace).
Check air inlet/air outlet
Pull out the mains plug and remove foreign
bodies from the air inlet/air outlet.
Clean the filter (see section "8.2 Cleaning
the filter") and/or descale (if necessary
replace).
Place the air humidifier on a level and flat
surface.
29
.
7
.
6