What If There Are Problems; Disposal; Technical Specifications - Beurer LB 37 Gebrauchsanweisung

Item
10 aroma pads
Anti-limescale filter (optional)

10. What if there are problems?

Problem
No LED display
Red LED
No mist is produced
The mist has a strange
smell
Strange noise
Mist escapes underneath
the water tank
The LED lights up red
although the tank is full

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of
its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.

12. Technical specifications

Dimensions (LxWxH)
Cable length
Mains voltage/frequency
Nominal power
Room size
Capacity
Evaporation output
Signs and symbols
Volume
Cause
The mains cable is not plugged in. Connect the plug.
The water level is too low; the wa-
ter tank is empty.
The LED display lights red .
The LED display does not light up.
The device is new.
Stale or dirty water.
The water tank is not positioned
correctly on the base unit.
There is too little water in the water
tank.
The device is not level and unsta-
ble.
The water tank is not positioned
correctly on the base unit.
The device evaluates the water
level incorrectly due to a fault.
approx. 21 cm x 11 cm x 25,5 cm
approx. 1.5 m
100 – 240 V AC / 50/60 Hz
max. 20 W
up to 20 m²
approx. 2 litres
200 ml/hour
The unit is double-protected and thus corresponds to protection class 2.
approx. 35dB
Item number
163.801
163.803
Solution
Fill the water tank.
Fill the water tank.
Remove the water tank, turn the screwed plug
and remove it.
Air the open, emply water tank in a cool, dry place
for twelve hours.
Empty the base unit and the water tank and clean
them thoroughly.
Fill the water tank with fresh water.
Lift up the water tank and position it correctly on
the base unit.
The tank should sit tightly on the base unit.
Fill the water tank.
Place the device on a firm, level surface.
Lift up the water tank.
Check whether the join between the base unit
and water tank is clean.
Clean if required.
Position the water tank correctly on the base unit.
The tank should sit tightly on the base unit.
Restart the device.
19