Technical Specifications; Warranty / Service - Beurer LB 12 Gebrauchsanweisung

11. Technical specifications

Size
Supply
Ultrasonic frequency
Evaporation output
Average active efficiency
Efficiency at low load (10 %)
No-load power consumption
Mains part

12. Warranty / Service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides
a warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused product
from the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively for
personal purposes in the context of domestic use.
German law shall apply.
During the warranty period, should this product prove to be incomplete or defective in functionality in
accordance with the following provisions, Beurer shall carry out a repair or a replacement delivery free
of charge, in accordance with these warranty conditions.
If the buyer wishes to make a warranty claim, they should approach their local retailer in the first
instance: see the attached "International Service" list of service addresses.
The buyer will then receive further information about the processing of the warranty claim, e.g. where
they can send the product and what documentation is required.
approx. 12 x 7.5 x 9 cm
Input: 100 – 240 V, ~50/60 Hz, 0.35 A
Output: 24.0 V
1.7 MHz
max. 80 ml/h
≥ 86.35 %
≥ 77.82 %
≤ 0.063 W
Manufacturer:
Shenzhen andsmps Electronics Technology Co. Ltd.
Model no.:
EU [680.05]: XYJ152400500V
UK [680.06]: XYJ152400500B
19
0.5 A, 12.0 W