Herunterladen Inhalt Inhalt Diese Seite drucken

Usage; Cleaning And Maintenance - Beurer LB 12 Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für LB 12:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
• Fill a 0.5 litre plastic water bottle with clean tap water, distilled water or still water. Do not use carbon-
ated water. The manufacturer expressly recommends the use of distilled water so as to avoid limescale.
The water temperature may be a maximum of 50 °C, so as to avoid damage to the device.
• Fasten a bottle adapter onto the bottle. There are two adapters available that fit most standard plastic
bottles:
• 1. "PC 1810" thread with a thread diameter of 28 mm and
• 2. "30/25" thread with a thread diameter of 30 mm.
• Turn the bottle upside down and place it in the top of the air humidifier. Do not compress the plastic
bottle. The base will fill with water automatically.
• Connect the power supply unit connector plug with the connector socket of the air humidifier and insert
the power supply unit into the socket. Ensure that the cable does not pose a trip hazard.
• Turn the control dial clockwise (to the right) to switch on the air humidifier.

7. Usage

IMPORTANT
• The immediate vicinity of the air humidifier may become damp. Reduce the nebulisation per-
formance or put the device in a more suitable place.
• Calcareous water can leave white deposits. Use distilled water instead.
• If the device should accidentally tip over, water may escape, even if the device is switched off
and unplugged.
• Check the humidity of your ambient air regularly. Intensive continuous operation can cause the
ambient air to become excessively humid. The relative air humidity should not exceed 60%.
• By turning the control dial to the right, you can adjust the nebulisation performance between "MIN"
and "MAX".
• Through operation, the device and the water in the base warm up.
• The air outlet is illuminated in blue when there is enough water.
• To switch the air humidifier on again, turn the control dial to the left.
• If there is not enough water, the device will switch OFF (red LED).
• Switch off the device when refilling the bottle with water. Change the water in the bottle every day so
that fresh water is always taken in.
• Switch off the device and pull out the plug when you are not using the air humidifier.
• Empty any remaining water when the device is not in use.

8. Cleaning and maintenance

Weekly cleaning and disinfection is a requirement for fault-free and hygienic operation.
WARNING
• Switch off the air humidifier each time before cleaning. Pull the plug out of the mains socket.
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis