Pool Manager Provider-Fehlercodes - HP StoreEasy 1000 Storage Handbuch

Tabelle 8 Storage Management Provider-Fehler (Fortsetzung)
Fehlercode Fehlermeldung
0x25005073 Failed to release the lock.
0x24005074 Failed to create the mutex.
0x24005075 Failed to get the proxy to the controller library.
0x25005076 The resiliency setting does not match the pool's
resiliency setting.
0x25005077 The operation was successful but the storage
provider cache is out of date. You must update the
storage provider cache before proceeding further.
0x25005078 The specified friendly name already exists.
0x20005079 The Storage Pool could not complete the operation
because its health or operational status does not
permit it.
0x2500507A One of the physical disks specified is assigned to
other storage pool.
0x2300507B This operation is supported only for spare drives.
0x2000507C The physical drive could not complete the operation
because its health or operational status does not
permit it.
0x2000507D One of the physical disks specified can not be
configured by the subsystem.
0x2300507E The specified pool does not contain witness lun
and hence cannot be shrunk.
0x2300507F This operation is not supported on primordial
storage pools.

Pool Manager Provider-Fehlercodes

Die Pool Manager Provider-Fehlercodes werden in
Tabelle 9 Pool Manager Provider-Fehler
Fehlercode
0x20006001
0x20006002
0x20006003
0x20006004
0x20006005
0x20006006
0x20006007
0x20006008
134 Fehlerbehebung und Wartung
Empfohlene Maßnahme
Aktualisieren Sie den Storage Management-Cache, indem
Sie den Windows PowerShell-Befehl
Update-StorageProviderCache aufrufen.
Starten Sie HP Storage Management Service neu.
Starten Sie HP Storage Management Service neu.
Aktualisieren Sie den Storage Management-Cache, indem
Sie den Windows PowerShell-Befehl
Update-StorageProviderCache aufrufen.
Aktualisieren Sie den Storage Management-Cache, indem
Sie den Windows PowerShell-Befehl
Update-StorageProviderCache aufrufen.
Aktualisieren Sie den Storage Management-Cache, indem
Sie den Windows PowerShell-Befehl
Update-StorageProviderCache aufrufen.
Aktualisieren Sie den Storage Management-Cache, indem
Sie den Windows PowerShell-Befehl
Update-StorageProviderCache aufrufen.
Wiederholen Sie den Vorgang.
Wiederholen Sie den Vorgang.
Wiederholen Sie den Vorgang.
Tabelle 9 (Seite 134)
Fehlermeldung
Pool Manager Provider has been unloaded from memory.
The Pool Manager Rule XML file is invalid.
Pool configuration is not supported for this enclosure.
Failed to initialize logger.
Could not find ROM Check Library (pssver.dll), which is required to find pool
template for any enclosure.
Failed to use WMI to call the SMP Provider.
Failed to connect to the SMP Provider.
General WMI error in the Pool Manager Provider.
aufgeführt.