Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5 Mounting
5.4
Insertion in panel cut-out
Step
Activity
1
Affix delivered panel seal (1) on the device from the rear
2
Insert the device into the panel cut-out from the front and ensure the panel seal is correctly
positioned so that no water or dirt can penetrate the case.
3
From the panel rear, slide the mounting brackets into the guides on the sides of the case. In
doing so, the flat faces of the mounting brackets must make contact with the case.
4
Place the mounting brackets against the panel rear and tighten evenly with a screwdriver
until the controller housing is firmly positioned in the panel cut-out.
5.5
Care and treatment of the front cover
The front plate can be cleaned with commercial detergents and cleaning agents.
NOTE!
The resistive touchscreen cover reacts to finger pressure or can be operated using commer-
cially available pens with a rounded plastic tip.
20
All manuals and user guides at all-guides.com
Werbung
Inhaltsverzeichnis
