Front Panel/Grille Assembly Fpan - Daikin FWH-AT Installations-, Bedienungs- Und Wartungsanleitung

Front panel/FPAN grille assembly
The front panel/grille, available in RAL9003, is delivered in a sep-
arate cardboard box:
Ū FPAN02 for models FWH-A 02-03-04
Ū FPAN06 for models FWH-A 06-07-08
Before installing the front panel: (Fig.11 )
Ū Remove the screws (1) securing the retainers (2) on each side
(remember to put these screws back in place after installa-
tion).
Ū To open the grille (3), move the two retainers (2) in the direc-
tion of the arrow.
Ū Open the grille (3) by 45°.
Ū Detach the control panel's safety cable (4) (remember to at-
tach it again after installation).
Ū Lift the grille to remove it from the control panel.
» Fig�11
To install the front panel: (Fig.12 )
Ū Turn the two locking clips (5) downwards.
Ū Attach the control panel of the panel (6) to the unit by means
of the two hooks (7), matching them to the locking clips (5).
Ū Check the exact position of the panel's control panel in re-
lation to the suspended ceiling. Adjust the position of the
indoor unit as necessary.
Ū Attach the panel's control panel to the unit using the special
screws and washers (8) provided.
Ū Put the grille (3) in place, making sure that the filter (9) is cor-
rectly positioned.
Ū Hook the safety cable to the control panel, close the grille,
and put the screws securing the retainers (2) back in place.
» Fig�12
31
WC66000644-02