eta 512-Serie Bedienungsanleitung Seite 53

Start (Cleaning)
1. Check that the main switch A6 is in the "I" position.
2. By pressing the buttons on the control panel (C1/C2) or using the remote control F start
the vacuum cleaner.
Standby mode (Pause)
Press the C1 button on the control panel or the F2 button on the remote control to interrupt
the ongoing cleaning and put the vacuum cleaner in standby mode.
Sleep mode
There are two ways to put the vacuum cleaner into sleep mode:
1. Press C1 button or approx. 3 seconds.
2. If the vacuum cleaner is in standby mode and no task is assigned to it for 10 minutes, it
will automatically go into sleep mode.
– From sleep mode, press C1 on the control panel or F2 on the remote control to put
the vacuum cleaner into standby mode.
– If the vacuum cleaner is in standby mode and close to the charging station, the
vacuum cleaner will park in the charging station after 10 minutes of inactivity.
5.4 CLEANING MODES AND VACUUM CLEANER FUNCTIONS
The vacuum cleaner has a total of 3 cleaning modes: Smart cleaning, classic cleaning,
local cleaning.
Smart automatic cleaning
Press the C1 button on the control panel or the F2 button
on the remote control. During cleaning, the vacuum
cleaner moves gradually and systematically in the
space according to the programmed route. It divides the
space into individual segments. As soon as the vacuum
cleaner cleans the entire available space, it automatically
searches for the charging station. This is the most used
method of cleaning
Classic cleaning
Press the C2 button on the control panel or the F6 button
on the remote control. When cleaning, the vacuum cleaner
moves freely around the room. It changes the direction
of movement when walls or other obstacles are detected.
Cleaning is carried out until the storage battery capacity is
exhausted. Then the vacuum cleaner automatically searches
for the charging station. This cleaning mode is especially
suitable for households with carpets.
Notes
EN - 53
EN