Phone Calls; Factory Settings - Niceboy Raze Supersonic Bedienungsanleitung

PHONE CALLS

To accept and then end the phone call, press the button (5). Long press the same button to
reject an incoming call.
LIGHTING MODE
Press button (3) to switch between individual color modes. Long press the same button to turn
off the light, long press to turn it back on.
Note: Higher energy consumption must be expected in active light mode.
TRUE WIRELESS (TWS) CONNECTION
Using True Wireless (TWS) technology, you can connect two Niceboy RAZE Supersonic speakers
together and play music simultaneously in stereo.
1. Turn on both Niceboy RAZE Supersonic speakers and make sure they are not connected
to any Bluetooth device (cell phone, laptop, etc.).
2. Briefly press the button (5) on one of the speakers. An acoustic signal announces the
successful completion of the speaker connection.
3. Now you can open the Bluetooth settings of your device. Then select „Niceboy RAZE
Supersonic" in the list of available devices. Successful pairing will be announced by an
acoustic signal.

FACTORY SETTINGS

In case of technical problems, reset the speaker to factory settings. The speaker must be
turned on. Press and hold the button (4) for 8 seconds. The speaker will first turn off and then
turn on again. Now the process is finished.
PARAMETERS
BT version:
Frequency band:
Radiofrequency power:
Transmission range:
Supported codecs:
Supported profiles:
Power output:
Impedance:
Sensitivity:
Frequency range:
Supported data storage devices:
Supported audio formats:
Battery:
5.0
2.4 GHz
≤ 2.5 mW
10 meters
SBC
A2DP, AVRCP, HFP
16 W
4 Ω
>88 dB
80 Hz – 20 kHz
USB flash drive, micro SD card, max. 32 GB
MP3, WMA, WAV
Li-Ion 1,800 mAh
12