AL-KO Solo 116 Betriebsanleitung Seite 21

Installation 116 / 118 L / 120 L
Parts overview
(Fig. 7)
1 String head
2 Drive plate
3 Guard
4 "Loop" bike grip
5 Handgrip, see "Starting the engine"
6 Eyelet
Caution!
The machine must not be operated before assem-
bly work has been completed.
Mounting the L-grip (Fig. 8)
1. Place the rubber sleeve (8-2) over the sup-
port bar.
2. Screw together the upper (8-3) and lower (8-1)
halves of the grip with four Allen screws (8-4)
through the rubber sleeve.
469680_c
Installation 116 B / 118 B / 120
Parts overview
(Fig. 10)
1 Cutter
2 Drive shaft
3 Guard
4 "Bike" grip
5 Handgrip, see "Starting the engine"
6 Strap attachment bar
Caution!
The machine must not be operated before assem-
bly work has been completed.
"Bike" grip (Fig. 11)
1. Place spring (11-1) in holder in support bar.
2. Place the lower grip holder (11-2) on the spring.
3. Place the marked (striated) area of the grip
rod (11-3) into the lower grip holder. The up-
per brace (11-4) must click into the lower brace
(11-2).
4. Fasten the upper brace (11-4) to the grip holder
with the screw (11-5).
5. The seat of the holder on the support bar can
be shifted as required.
Fuel and consumables
Safety instructions
Warning!
Petrol is highly flammable – Fire hazard!
Ensure that no fuel leaks from the engine, tank
„
or fuel lines.
Only mix and store petrol in approved containers.
„
Do not use any fuel mixture that has been stored
„
for more than 90 days.
Only refuel outdoors.
„
Do not smoke while refuelling.
„
Do not open the fuel cap while the engine is run-
„
ning or hot.
Exchange the tank or fuel cap if damaged.
„
Always keep the fuel cap firmly closed.
„
GB
21