Connection­and­preparation - Grundig CMS 2000 BT Bedienungsanleitung

CONNECTION­AND­PREPARATION
Connecting­the­loudspeakers
1
Insert the wires of the loudspeaker cable into
the »SPEAKER­OUTPUT­(4­�)­R­­L« fasten-
ers on the hi-fi system.
Note:
Observe the left and right channels (L = left
7
channel, R = right channel).
Connecting­the­antenna
1­Plug the roof antenna cable into the antenna
socket »FM­ANTENNA« on the hi-fi system.
Note:
If no roof antenna is available, use the
7
auxiliary antenna supplied. When suitably
positioned and with adequate signal, this
antenna provides adequate reception of
FM channels. Do not shorten the auxiliary
antenna.
Connecting­an­MP3­player­or­a­
USB­memory­stick
Caution:
The hi-fi system must be switched off while
7
the USB connection is being made. If it is
not switched off, data can be lost.
1
Connect the USB interface of the MP3 player
to the » « socket of the hi-fi system with a
standard USB cable;
or
insert the USB plug of the USB memory stick
into the USB interface »
system.
24­
ENGLISH
« of the hi-fi
Connecting­external­devices
Note:
Switch the hi-fi system off before you con-
7
nect external devices.
1 Use standard audio cables (3,5mm) to cona -
nect the audio outputs of the external device
to the »AUDIO­IN« sockets on the hi-fi
system.
Connecting­the­power­cord
Notes:
Check that the mains voltage on the type
7
plate (on the bottom of the hi-fi system)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
All the other devices/loudspeakers must be
7
connected before you connect the power
cord.
1 Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains
7
with the power cord. Pull out the power
plug if you want to completely disconnect
the hi-fi system from the mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
­---------------------------------------