Getting Started; Connection­and­preparation; Connecting­to­the­network - Grundig CMS 5000 Bedienungsanleitung

GETTING­STARTED
Connection­and­Preparation­
Connect to the speaker using the cable with
2-pin connectors. Screw the connectors into the
speaker out terminals at the rear of the main unit
and the speakers.
Screw the external WiFi antenna for wireless
network connection.
Connect the copper cable to the red (+) jack and
connect the silver cable to the black (-) jack.
Plug the wire DAB/FM antenna for DAB and
FM reception.
Plug the power cord into power socket, the
device starts up.
Connecting­to­the­network
Power on your device and connect to a wire-
7
less access point, router or similar net-work
device.
The network device needs to support WiFi
7
(802.11 a/b/g/n) wireless connection.
Make sure you have setup the wireless network
and you have the WEP, WPA or WPA2 security
password to activate the connection. You may
also use the WPS (WiFi Protected Setup) function
for easy pairing between the network device and
CMS 5000 BT DAB+ WEB/ M 4050 BT DAB+
WEB Check if the light indicators on the network
device are in appropriate status.
Using­CDs­
The device is suitable for music
CDs displaying the logo shown
here (CDDA) and for CD-Rs and
CD-RWs with audio data. You
can play standard 12 cm CDs
on your device. The radio is able to play CD-R
and CD-RW discs containing MP3 and WMA
files. It is assumed in this section that a file is
equivalent to a CD track.
An MP3 / WMA CD may not contain more than
999 files and not more than 99 folders. MP3
and WMA files should be created with standard
audio sample rate of 44.1kHz.
­------------------------------------------------------------------------------------------------------
MP3 and WMA data rates up to 320 kilobits per
second are supported. WMA Lossless files are
not supported. The unit will not play files which
include digital rights management (DRM) protec-
tion. When burning CD-R and CD-RW discs with
audio files, various problems may arise which
could lead to problems with playback. Typically
such problems are caused by poor CD writing
or audio encoding software, or by the hardware
settings of the PC's CD writer, or by the CD being
used. Should such problems arise, contact the
customer services of your CD writer or software
manufacturer or look in their product documen-
tation for relevant information. When you are
making audio CDs, take care to observe all legal
guidelines and ensure that the copyright of third
parties is not infringed.
Connecting­a­USB­memory­stick­
Insert the USB plug of a USB memory stick into
the USB port at the front of the device. The sys-
tem of the USB must be FAT 16, FAT 32. It is not
compatible with NTFS or other systems.
Connecting­an­audio­source­
via­RCA­audio­in
Use a standard RCA audio cable to connect
the audio output from the external device to the
audio input sockets on the back of the device.
Connecting­the­headphones­
Turn the volume down before using the head-
phones.
Inset the headphone plug (standard 3.5mm) into
the headphone socket at the front of the device.
General­Device­Functions
On the playing screen, rotate the volume knob
or press » +« / »
adjust the volume. Switch off the sound by press-
ing » « on the remote control.
Press »
remote control to select modes.
« on the remote control to
/­ MODE« on the device or on the
ENGLISH
27­ ­