Maintenance; Optional Accessories - Makita JS3201 Bedienungsanleitung

Shearing method
Fig.9
For smooth cuts, tip the tool slightly backward while
advancing it.
Maximum cutting width
Fig.10
Stay within the specified maximum cutting width (A):
Case of length 1,800 mm.
Mild steel (thickness)
Max. cutting width (A)
Stainless (thickness)
Max. cutting width (A)
006432
Minimum cutting radius
Minimum cutting radius is 50 mm when cutting 2.3 mm
mild steel.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
Replacing carbon brushes
Fig.11
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.12
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
3.2 mm Under 2.3 mm
90 mm No limit
2.5 mm Under 2.0 mm
70 mm No limit
or attachments
Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Blades
•
Hex wrench
•
Thickness gauge
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
are
6