Cameo F4 FC Bedienungsanleitung Seite 13

DEVICE SETTINGS (Settings)
Starting from the main display, press on the right push button rotary encoder to move to the main menu. Rotate the left encoder (SELECT) to select
"Settings" menu item (as indicated by selector arrow on left) and confirm by pressing the left encoder (ENTER). This will take you to the submenu
for setting the submenu options (see table, select via SELECT, confirm via ENTER, change value or status via SELECT, confirm via ENTER).
Settings
Display Flip =
Display Time off =
DMX Fail =
Dimmer Curve =
Dimmer Response =
Red Shift =
PWM-Frequency =
Color Calibration =
Autolock =
Fan =
Standing Position
Display rotation
Hanging Position
Display always on
Display lighting
Display off after 20s
Hold
Operational status with
Blackout
DMX signal fault
User Color 8
Linear
Exponential
Dimmer curve
Logarithmic
S-Curve
LED
Dimmer response
Halogen
Accurately mimics the No
colour drift of dimming a
halogen spotlight. When
dimming the spotlight,
the colour temperature
Dim To Warm
changes automatically to
increasingly warm white
and amber (and vice
versa).
600 Hz / 1200 Hz /
LED PWM frequency 2000 Hz / 4000 Hz /
6000 Hz / 25k Hz
RAW - Off
RAW - Adjust
(Individuelle, betriebs-
artübergreifende
Anpassung von R, G,
B, und W mit Werten
von jeweils 000 bis
Colour calibration
255)
Calibrated
Smart Calibration
On
Automatic locking of the
controls
Off
Auto
Fan setting
Off
No rotation of the display
Display is rotated by 180° (e.g. for overhead installation)
Permanently on
Deactivates after approximately 20 seconds of
inactivity
Last command is retained
Activates blackout
Activates User Colour 8
Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values
Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
Light responds abruptly to changes in DMX value
Light behaves like a halogen spotlight with slight
brightness changes
Colour drift is disabled
Colour drift is enabled
Configuration of LED PWM frequency
R, G, B and W with maximum value 255
Press middle encoder = switch between R+G and
B+W (colour) Rotate middle encoder = set value
of R or B
Press right encoder = one level up in menu
structure (ESC)
Rotate right encoder = set value of G or W
Press left encoder = confirm and save settings
Factory calibration of R, G, B and W (across all
modes). Select this setting for the correct display of
colour shades and presets in the standalone modes
CCT and Gel, as well as when controlling CCT and
the presets Gel via DMX.
Merge Factory (calibrated) and RAW calibration
Automatic locking of the controls after approxima-
tely 30 seconds of inactivity. Display shown upon
attempted use: "Locked!"
Unlock: Simultaneously press the centre and right
encoders for approx. 3 seconds
Automatic locking of the controls is disabled
Automatic fan control
Deactivated fan with greatly reduced brightness
13