Operation - GRAUPNER 7598 Bedienungsanleitung

Operation

Activate the balancer function
Can cel
Disc harge Bal ance
Mod e
Can cel
Disc harge Bal ance
Mod e
Can cel
Disc harge Bal ance
Mod e
14 Operation
Connect the battery on the right side balancer jacks so that the display is
activated.
EH-jack only: note the marked GND-, here the negative terminal of the ba-
lancer must be inserted!
The individual cell voltages on the left and the symbols for the number of
cells appear to the right, also the total voltage „Total" at the bottom of the
display.
1. Now press the button
2. The balancer accepts the lowest cell voltage as a reference and starts
the balancing process indicated by the scale icon. The fl ashing
appears behind these cells which are currently balanced active.
The balancer balances or discharge the individual cells to the voltage of
the cell with the lowest voltage. This process stops when all cells are
within 0.01 V.
3. The balance process is complete when all
the button „Cancel" to exit. You can now disconnect the battery.
Note: You can cancel the ongoing balancing process at any time by pres-
sing the „Cancel" button.
You can also connect the balancer to the battery while you charge it on the
charger. Note especially the voltage on the display: when fl uctuating abnor-
mally or even the message „Check Battery" appears, stop the charging
process immediately and disconnect the battery pack to avoid damaging
the battery or charger!
Note in each case the charging instructions for your charger!
„Balance" once.
icons are off. Now press
icon