Protecting The Pressure Washer With Antifreeze - Stihl RE 95 Gebrauchsanleitung

12 After Finishing Work
► Remove high-pressure hose and let the remaining water
run out of the high-pressure hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the remaining water run out
of the spray gun.
► Clean the pressure washer.
► Push hose (1) into holder (2).
3
5
4
10
9
► Wind up the high-pressure hose (3) evenly distributed.
► Push hose (4) into holder (5).
► Coil the connecting cord (6) on the holder (7).
► Secure the connecting cord (6) using the clip (8).
► Insert spraying set (9).
► Insert nozzle (10).
0458-815-9621-A
► Store the spray attachment in the holders (11) on the

12.2 Protecting the pressure washer with antifreeze

If the pressure washer cannot be protected from frost during
transport or storage, the pressure washer should be
protected by a glycol-based antifreeze. The antifreeze
prevents water inside the pressure washer from freezing and
causing damage to the pressure washer.
► Remove spray lance
► Connect the shortest possible water hose to the pressure
► Mix the antifreeze as described in the antifreeze
6
7
8
► Pour antifreeze into a clean container.
► Insert water hose into container of antifreeze.
► Squeeze and hold spray gun trigger.
► Switch on pressure washer.
► Hold down spray gun trigger until an even jet of antifreeze
► Press and release spray gun trigger several times.
► Switch off pressure washer and unplug mains plug from
► Detach spray gun, high-pressure hose and water hose
11
11
11
pressure washer.
washer.
The shorter the water hose, the less antifreeze is needed.
Instruction Manual.
is delivered from the spray gun and point the spray gun
into the container.
the socket.
and allow antifreeze to run into the container.
English
11
11
59